Re: [Healeys] 100-4 Lower Windshield Seal Source

[Bob Spidell <bspidell@comcast.net>]

A known problem. Someone had a batch of properly molded seals made up a few 
years ago, but I believe they all found good homes, and no one else has come 
forth with a solution. 

If you find some, please let us know. 

Bob 

----- Original Message -----



Does anyone have a source for the rubber strip that goes between the bottom of 
the windshield frame and the top of the body? I've tried the one from Moss, and 
also one I bought on eBay and they are not molded to accommodate the curve of 
the body and thus leave an unsightly gap on both sides. I was looking at a 
couple of other BN1's yesterday, and their moldings were old but fit the 
contour of the body perfectly. Someone suggested a possible source in 
Australia. Any help will be greatly appreciated. 
_______________________________________________ 
_______________________________________________
Archive: http://www.team.net/archive

Healeys@autox.team.net
http://autox.team.net/mailman/listinfo/healeys