Re: [Healeys] BN2 Scuttle-Door Seal

[Bob Spidell <bspidell@comcast.net>]

Thanks, Michael.  I believe the seals are different on BN2s than on BN1s; did 
you install the 'BN2 style?'


On 12/29/2014 10:16 AM, Michael Oritt wrote:
> Bob--
>
> I installed these on my BN1 but since I am not sure I did so in keeping with 
> what was original I doubt photos will do 
> you any good.
>
> FWIW I did this to remedy a persistent water leak onto my thigh when driving 
> in the rain.  The modification did 
> succeed in moving the leak onto my calf.
>
> Best--Michael Oritt
>
>
>     BN2s have a rather elaborate seal contraption along the outside edges of 
> the scuttle and the top front part of the
>     doors (the seal is held by a hook-shaped strip of metal and some 
> quarter-round pieces which are screwed to the
>     inner part of the door hinge part). Does anyone have a good set of photos 
> of these?
>
>     The Moss parts come with good instructions, but it seems both screws and 
> pop rivets are used; I need to know which
>     goes where.
>
>     TIA,
>     Bob
>
>     --------------------------------
>     Bob Spidell - San Jose, CA
>
>
>
>
>
>


-- 
*******************************************************************
Bob Spidell           San Jose, CA            bspidell@comcast.net

*******************************************************************

_______________________________________________
Archive: http://www.team.net/archive

Healeys@autox.team.net
http://autox.team.net/mailman/listinfo/healeys