Hi Andy,
The pic of a spin on filter fitted into the original housing looks like a
nice solution. Old style looks but comfort of new technic. Did you build
this yourself or is it available somewhere? Anyone knows if available for a
100 too?
Reinhart
Reinhart Rosner
55 100 BN 1
Vienna - Austria
-----Ursprüngliche Nachricht-----
Von: Healeys [mailto:healeys-bounces@autox.team.net] Im Auftrag von Andy
Thorp
Gesendet: Mittwoch, 31. Dezember 2014 22:09
An: healeys@autox.team.net
Betreff: Re: [Healeys] texas cooler
The PO of my car inadvertently ruined the engine in 2000 miles by using the
original oil filter. The bypass valve in the filter head was stuck open with
crud which effectively eliminated the filter from the system and scored all
the bearings.
Re the first start no oil pressure problem with a spin-on filter- the drain
back valve flap takes a few psi to push it open and a dry oil pump can't
make any pressure. Just unwind the filter a couple of turns and crank it for
a few seconds to let the air out, then you are in business.
Pic attached of a spin on filter fitted into the original housing to get
around the problems of the old filter without the ugliness of the spin on
ones.
Andy.
--------------------------------------------
On Thu, 1/1/15, s.hutchings@rogers.com <s.hutchings@rogers.com> wrote:
Subject: Re: [Healeys] texas cooler
To: "Team.net" <lawrence.swift@gmail.com>
Cc: "<healeys@autox.team.net>" <healeys@autox.team.net>
Received: Thursday, 1 January, 2015, 8:39 AM
This subject interests me
because I find my engine's oil pressure takes a little longer than I would
like to come up, when cold. I haven't timed it, so it's just an impression.
I have the original canister type filter arrangement.Having said that,
it's always full of oil when I change it.
Stephen, BJ8
Sent from my iPad
> On Dec 31, 2014, at 11:05 AM, Team.net <lawrence.swift@gmail.com>
wrote:
>
> I recently
had the engine on the BT7 rebuilt as the thrust washers in the bottom end
fell out resulting in damage to the block. Prior to the rebuild I had
installed an oil filter conversion which worked just fine. After rebuild,
we could not raise oil pressure (yes, the spin on was replaced
correctly) after trying numerous times. Replaced the spin on conversion
with the original unit and instantly got pressure.
>
> Not
sure why.
>
> Larry
Swift
_______________________________________________
Archive: http://www.team.net/archive
Healeys@autox.team.net
http://autox.team.net/mailman/listinfo/healeys
ox.team.net
|