healeys
[Top] [All Lists]

Re: [Healeys] Is the List down? and question about power supplies for Ea

To: "'John Vrugtman'" <javrugtman@htcnet.org>
Subject: Re: [Healeys] Is the List down? and question about power supplies for Eastwood plater
From: "Simon Lachlan" <simon.lachlan@homecall.co.uk>
Date: Tue, 2 Jun 2015 14:22:38 +0100
Cc: 'Healey List' <healeys@autox.team.net>
Delivered-to: mharc@autox.team.net
Delivered-to: healeys@autox.team.net
References: <rn8imap9im2oja1dbq1uqhe6nlet31cv2b@4ax.com> <556DA7C6.1030606@htcnet.org>
Thread-index: AdCdNEJNfiYQKMI5TcSUmUmQ5mOg6QAAmuNg
If you had an old battery charger you might be able to solder onto the + & -
outputs on one of its D cell slots. Presumably that would give you a
constant 1.5 volts?
Mind you, you could use rechargeable D cells. However, I'd guess they'd be
pretty feeble.
Simon

-----Original Message-----
From: Healeys [mailto:healeys-bounces@autox.team.net] On Behalf Of John
Vrugtman
Sent: 02 June 2015 13:56
To: healeys@autox.team.net
Subject: Re: [Healeys] Is the List down? and question about power supplies
for Eastwood plater

Caswell has one. 
http://www.caswellplating.com/electroplating-anodizing/replenishment-chemica
ls.html

On 5/29/2015 10:47 PM, sentenac.rw@gmail.com wrote:
> Is the List down?  Has it been down for the past two days?  Or have I 
> been voted off the Healeys List island?
>
> I have an Eastwood plating kit that uses two D cells to provide the 
> power.  It works but it wears out batteries pretty fast.  I was 
> wondering if anyone had come up with a power supply that worked well 
> as a replacement.
>
> -Roland
>


_______________________________________________
$12.75
Archive: http://www.team.net/archive

Healeys@autox.team.net
http://autox.team.net/mailman/listinfo/healeys

http://autox.team.net/mailman/options/healeys/simon.lachlan@homecall.co.uk

_______________________________________________
Archive: http://www.team.net/archive

Healeys@autox.team.net
http://autox.team.net/mailman/listinfo/healeys


<Prev in Thread] Current Thread [Next in Thread>