Re: [Healeys] Is the List down? and question about power supplies for Eastwood plater

[Bob Spidell <bspidell@comcast.net>]

Note a charger has to supply greater than the nominal battery voltage in 
order to overcome the internal resistance of the battery.  Also, if the 
plater has less load than the internal resistance of the batteries you 
could overload the charger.

I think Kees' suggestion of a DC power supply sounds like the best bet.

Bob

On 6/2/2015 6:22 AM, Simon Lachlan wrote:
> If you had an old battery charger you might be able to solder onto the + & -
> outputs on one of its D cell slots. Presumably that would give you a
> constant 1.5 volts?
> Mind you, you could use rechargeable D cells. However, I'd guess they'd be
> pretty feeble.
> Simon
>
>
> Caswell has one.
> http://www.caswellplating.com/electroplating-anodizing/replenishment-chemica
> ls.html
>
> On 5/29/2015 10:47 PM, sentenac.rw@gmail.com wrote:
>> Is the List down?  Has it been down for the past two days?  Or have I
>> been voted off the Healeys List island?
>>
>> I have an Eastwood plating kit that uses two D cells to provide the
>> power.  It works but it wears out batteries pretty fast.  I was
>> wondering if anyone had come up with a power supply that worked well
>> as a replacement.
>>
>> -Roland
>>
>>
>>

_______________________________________________
Archive: http://www.team.net/archive

Healeys@autox.team.net
http://autox.team.net/mailman/listinfo/healeys