Charlie,
This can be because the sender is incorrectly oriented and the float is hanging
up on the edge of the "well" rather than
going down into it all the way.
Try rotating the sender 180 degrees.
Also helps to run a separate ground wire from the sender to the chassis.
--
Steve Gerow
Altadena, CA
BN6 w lotsa mods
> -------Original Message-------
> From: Charlie Schott <schottc@knology.net>
> To: Steve B. Gerow <steveg@abrazosdata.com>, healeys@autox.team.net
> Subject: Re: [Healeys] Gas Gauge
> Sent: Aug 25 '15 10:04
>
> When the gas gauge on my 1960 BT7 reads 1/4, I'm out of gas. Can the sending
> unit or the gauge be adjusted? Thanks.
>
> Regards,
>
> Charlie Schott
>
>
>
>
> _______________________________________________
> Support Team.Net http://www.team.net/donate.html
> Suggested annual donation $12.75
> Archive: http://www.team.net/archive
> Forums: http://www.team.net/forums
>
> Healeys@autox.team.net
> http://autox.team.net/mailman/listinfo/healeys
>
> Unsubscribe/Manage:
> http://autox.team.net/mailman/options/healeys/schottc@knology.net
>
>
_______________________________________________
Archive: http://www.team.net/archive
Healeys@autox.team.net
http://autox.team.net/mailman/listinfo/healeys
ox.team.net
|