Hi Bob,
Well sorry to tell you but there are four studs welded to the bottom of each
seat pan that penetrate down through the rear seat deck and four nuts securing
them in place. The only access to remove the nuts is from underneath the car
which to me is harder to get to than just pulling the right rear wheel and
exposing the fuel pump for service. I have seen some bj8's with chrome screws
going down through the upholstered seat pans into the deck for easier access
from above. It just depends on what you like. I think the bj7's and earlier
cars have the screws for removal of the pans but I'm not 100% sure of that.
Hope this helps,
George Haywood
'65 bj8
---- Bob Spidell <bspidell@comcast.net> wrote:
> Listers,
>
> Believe it or not, I've never removed the rear seat pans on my BJ8. It struck
> me that this might be an easier way to R&R a fuel pump, and I need to get to
> the underside to replace the vinyl strips that seal the holes in the pans;
> anyone got an "Austin-Healey BJ8 Rear Seat Pans Removal for Dummies" guide?
>
> TIA,
> Bob
>
> --------------------------------
> Bob Spidell - San Jose, CA
>
_______________________________________________
Archive: http://www.team.net/archive
Healeys@autox.team.net
http://autox.team.net/mailman/listinfo/healeys
|