Re: [Healeys] FW: BJ8 Bonnet/hood hinge removal and replace anti-rattle washers

[Rfbegani <rfbegani@speakeasy.net>]

Thanks for the suggestion. Will try it. 

Sent from my iPhone

> On Dec 1, 2016, at 2:19 PM, Perry <healeyguy@aol.com> wrote:
> 
> The factory installed the rubber buffers on the shroud lip so that the hood / 
> bonnet would have something to support it between the hinges and the front 
> latch. If you don't see a small mark on your bonnet paint were the buffers 
> are, chances are there is no support. Try laying a 1/16 inch thick piece or 
> rubber (old inner tube) on top of the buffer and close the bonnet. See if the 
> hood still shakes.  It may take two. When the buffers are  in contact the 
> bonnet will not shake side to side. Permanent solution is to properly install 
> the buffers. 
> Perry
> 
> Sent from my iPhone
>> 
> 
> 

_______________________________________________
Archive: http://www.team.net/archive

Healeys@autox.team.net
http://autox.team.net/mailman/listinfo/healeys