The workshop manual does not specify a torquing sequence, but I do it like
Bob does.
Steve Byers
HBJ8L/36666
BJ8 Registry
AHCA Delegate at Large
Havelock, NC
From: Healeys [mailto:healeys-bounces at autox.team.net] On Behalf Of Bob
Spidell
Sent: Saturday, March 25, 2017 11:59 AM
To: healeys at autox.team.net
Subject: Re: [Healeys] Rocker Shaft Installation, 6 cyl engine
Absent a specific sequence, I always torque from the middle out, alternating
sides.
Bob
ps. They're studs--unless someone has changed yours--so you're torquing
nuts.
On 3/25/2017 12:08 AM, John Spaur wrote:
Shouldn't be. It's not like you are torqueing the head.
John Spaur
'62 BT7
From: Healeys [mailto:healeys-bounces at autox.team.net] On Behalf Of gturl
gturl
Sent: Friday, March 24, 2017 8:55 PM
To: healeys at autox.team.net
Subject: [Healeys] Rocker Shaft Installation, 6 cyl engine
Is there a preferred sequence for tightening the bolts holding the rocker
shaft pedestals to the head?
Thanks in advance..
Geoff Turl
<http://www.avg.com/email-signature?utm_medium=email&utm_source=link&utm_cam
paign=sig-email&utm_content=emailclient> Image removed by sender.
Virus-free.
<http://www.avg.com/email-signature?utm_medium=email&utm_source=link&utm_cam
paign=sig-email&utm_content=emailclient> www.avg.com
-------------- next part --------------
An HTML attachment was scrubbed...
URL:
<http://autox.team.net/pipermail/healeys/attachments/20170325/9310671f/attachment.html>
-------------- next part --------------
A non-text attachment was scrubbed...
Name: image001.jpg
Type: image/jpeg
Size: 350 bytes
Desc: not available
URL:
<http://autox.team.net/pipermail/healeys/attachments/20170325/9310671f/attachment.jpg>
|
