Come on you guys. Unless the block has ben treated to a more modern pressurized
timing chain tensioner?what you are looking at is the remains of the large flat
O ring that serves as the timing chain tensioner on 100?s. Bet the cam timing
is off a bit too!
Perry
Sent from Mail for Windows 10
From: Michael Oritt
Sent: Sunday, September 24, 2017 6:04 PM
To: Austin Healey; Michael Clifford JR
Subject: [Healeys] (no subject)
There has been a slow, gradual decline in my engine's oil pressure for a while
now--60 to 65 psi on start-up from cold dropping at running temperatures to
30-35 psi at 3K rpm's and 10 psi or less at fast idle. Yesterday I took the car
for a long ride and after a while at 65-70 mph the oil pressure actually
dropped below 30 psi, so it's now officially below the "10 psi/1K rpm's"
threshold.?
The engine has about 60K on it since complete rebuild so this morning I decided
to bite the bullet and drop the sump with the hope that I will find nothing
worse than a worn oil pump and/or main or rod bearings, either of which I can
repair/replace in time for some fall driving.?
I first removed the spin-on oil filter and upon cutting it apart noticed a bit
of black plastic debris--irregularly shaped pieces, almost gravel-like perhaps
1/16" to 1/8" in dimension on one end of the cartridge. The filter medium
itself was fairly clean though I did notice a bit more shiny bearing-like
material than I would have liked to have seen.
While draining the pan I heard a clunk or two from some solids going through
the drain hole and landing in a catch pan and on examination I found a couple
of larger pieces of the same kind of stuff--definitely some black plastic
material, not particularly hard as it would give when bitten.?
The big surprise was what I found when I removed the pan--a lot more of the
same small stuff and four segments of a black plastic piece. In the attached
thumbnail you'll see that they form a semi-circle about 5" in diameter and
notice on the two pieces in the 9 o'clock position that there appears to have
been some gear-like teeth molded in. The small debris is inside the semi-circle.
I'm going to remove the oil pump tomorrow but wonder if anyone has an idea as
to what this stuff could be?
-------------- next part --------------
An HTML attachment was scrubbed...
URL:
<http://autox.team.net/pipermail/healeys/attachments/20170924/0154f34d/attachment.html>
|