| To: | "LSR Group" <land-speed@autox.team.net> |
|---|---|
| Subject: | Air tool question |
| From: | "JERRY FOSTER" <fosterap@flash.net> |
| Date: | Sun, 3 Feb 2002 16:50:02 -0600 |
If you were going to cut a bunch of sheet aluminum, would you get a "nibbler", or a "shear" air tool? I'm thinking the shear is the way to go, but any advice welcome. Thanks! Jerry in Dallas /// unsubscribe/change address requests to majordomo@autox.team.net or try /// http://www.team.net/mailman/listinfo /// Archives at http://www.team.net/archive/land-speed |
| <Prev in Thread] | Current Thread | [Next in Thread> |
|---|---|---|
| ||
| Previous by Date: | Re: Engine Rules, landspeedracer |
|---|---|
| Next by Date: | New Member Greetings, SMITH KENTON E |
| Previous by Thread: | Re: Engine Rules, Bill Smith |
| Next by Thread: | RE: Air tool question, Albaugh, Neil |
| Indexes: | [Date] [Thread] [Top] [All Lists] |