Cam shaft bearings

[LGMCAFEE@aol.com]

Scott I remember seeing an article in a book where they took an old cam and 
cut some slits in the cam with a thin cut off wheel and used that to ream out 
the bearings that were to tight. In thinking back I did that to one motor 
years ago.
Larry Mac

///  unsubscribe/change address requests to majordomo@autox.team.net  or try
///  http://www.team.net/mailman/listinfo
///  Archives at http://www.team.net/archive/land-speed
///  what is needed.  It isn't that difficult, folks.