| To: | "LSR list" <land-speed@autox.team.net> |
|---|---|
| Subject: | DIY distributor cap |
| From: | "atrav" <atrav@copper.net> |
| Date: | Sun, 10 Jul 2005 09:42:03 -0400 |
What would be a good material to fabricate a distributor cap from? I was thinking a block of nylon, then using screw in brass terminals. Is there a rule for how far apart the terminals should be spaced to prevent arcing from one to another? I was just going to measure a bunch of factory stock ones... TIA, -Aron- |
| <Prev in Thread] | Current Thread | [Next in Thread> |
|---|---|---|
| ||
| Previous by Date: | RE: Motor City Flatheads, John L Staiger |
|---|---|
| Next by Date: | RE: DIY distributor cap, Dave Dahlgren |
| Previous by Thread: | Motor City Flatheads, Jane McMeekin |
| Next by Thread: | RE: DIY distributor cap, Dave Dahlgren |
| Indexes: | [Date] [Thread] [Top] [All Lists] |