Get a piece of 1 1/4 inch sink trap pipe from your local hardware store . .
. the trumpet shaped piece for bathroom sinks, and cut it to about four
inches long, maintaining the flare at one end. Drill two 1/4 inch holes,
opposite each other about an inch below the flare end.
Drive the pipe down into the filler opening, protecting the flare with a 2
by 4, until the flare seats against the cork seal.
Best 15 minute job I ever did for my car.
Andy Moyce
52 TD
///
/// mg-t@autox.team.net mailing list
///
|