| To: | mg-t <mg-t@autox.team.net> |
|---|---|
| Subject: | Re: Hand Crank Mystery |
| From: | Bullwinkle <yd3@nvc.net> |
| Date: | Tue, 20 Apr 2004 16:36:13 -0500 |
MY factory original crank is 3/4" in diameter with the pin end reduced to 5/8". The pin is at 90 degrees to the crank and the handle has a sheet metal cover which rotates. Blake /// unsubscribe/change address requests to majordomo@autox.team.net or try /// http://www.team.net/mailman/listinfo /// Archives at http://www.team.net/archive/mg-t |
| <Prev in Thread] | Current Thread | [Next in Thread> |
|---|---|---|
| ||
| Previous by Date: | Re: rev limits, Bob Howard |
|---|---|
| Next by Date: | Question, Rocky Frisco |
| Previous by Thread: | Re: Hand Crank Mystery, Lawrie Alexander |
| Next by Thread: | seat belts installation TC, Tim Newton |
| Indexes: | [Date] [Thread] [Top] [All Lists] |