Re: Valve seals -TC

[Bullwinkle <yd3@nvc.net>]

I replaced the oil shield and retainer with hardened alluminum ones.  Then used 
a matched set of the lightest tension springs I could come up with. 
That raised the RPM limit as wells as reducing the wear on the cam and lifters.

Regards,
Blake

///  unsubscribe/change address requests to majordomo@autox.team.net  or try
///  http://www.team.net/mailman/listinfo
///  Archives at http://www.team.net/archive/mg-t