Text item:
Nick wrote:
/>This is all so I can pass emissions in
/Colorado... >
/>I'm experiencing problems in finding a bushing to hold a pipe into a
/>threaded hole normally used for the EGR valve connection into the exhaust
/>manifold on the 1500cc engine.
/>
/>The machine shop removed a piece of threaded "something" that had been
/>filled in with welding to prevent exhaust gases from leaking out.
/>Anyway, they said it was 3/4 inch, 14 threads per inch. Is this
/>available anywhere stateside???
/This is most likely the standard pipe thread size (3/4-14npt) which is
/actually tapered slightly, hence a standard bolt thread will seem to "bind
/up" after a few turns, when it started out "loose".
/>Secondly I need to find some kind of heat proof pipe to go from this
/>junction in the manifold to an air pump inconveniently mounted on the
/>opposite side of the engine.
If this is the case, you can buy a fitting with pipe thread on one end and
a compression fitting on the other end, where you can insert metal tubing
of choice. If you can't find it in a good hardware store, then go to a
place that sells industrial valves and fittings.
Mike
Text item: External Message Header
The following mail header is for administrative use
and may be ignored unless there are problems.
***IF THERE ARE PROBLEMS SAVE THESE HEADERS***.
Reply-To: "jpratchi" <jpratchi@isdlink1.ess.harris.com>
Precedence: bulk
Sender: owner-triumphs@triumph.cs.utah.edu
Subject: Re: T H R E A D size...
To: mgs@autox.team.net, triumphs@autox.team.net,
Nick Benson <grayoak@holly.ColoState.EDU>
Message-Id: <9509248145.AA814544955@isdlink1.ess.harris.com>
From: "jpratchi" <jpratchi@isdlink1.ess.harris.com>
Date: Tue, 24 Oct 95 07:22:23 est
for triumphs-outgoing; Tue, 24 Oct 1995 07:22:45 -0400
h SMTP id HAA19725; Tue, 24 Oct 1995 07:23:12 -0400
95 04:23:18 -0700
(Smail3.1.28.1 #3) id m0t7hO1-000S0Ya; Tue, 24 Oct 95 04:19 WET DST
|