At 09:01 AM 1/6/96 -0500, you wrote:
>I thought I was ready to pull the engine. Maybe not. Do I have to take
>up all the floorboards and drive shaft tunnel and remove the remote
>gearchange assembly first? If it can be done otherwise, I'd rather, as
>I'm working in a very confined space. Do I have any other options or is
>that the only way?
>Kevin Sullivan -- 1960 MGA
>Nichols Research Corp.
>Shalimar FL USA
Just remove the small cover around the shift lever.(You may need to take off
the shift lever.) Have a good load-leveler and go slowly, It really will
But if you are only taking out the engine you can do that without the
J R Ferguson