[Top] [All Lists]

Re: TD Door Fitting

Subject: Re: TD Door Fitting
From: (Robert J. Donahue)
Date: Mon, 4 Aug 1997 22:59:13 -0600 (MDT)
>     Where did you get them??
>    Ed
I bought the hinges from Moss. Turns out the right
hand side needed 1/8 inch removed to make the door fit.
I did this with a hand held electric grinder.

The left hand side was just right the way it was. Before
any more grinding, I measured the door opening and discovered
it is exactly 1/8 inch wider than the right.

So I guess each door is somewhat of a custom job. It would
be nice if the replacement hinges were made on the skinny
side and supplied with shims.

Bob Donahue 'Still Stuck in the '50s'           
52 MG-TD #17639 under DIY restoration, NEMGTR #11470
71 MGB still in shop, 20 months and counting

<Prev in Thread] Current Thread [Next in Thread>