--WebTV-Mail-537818945-1138
Content-Type: TEXT/PLAIN; CHARSET=US-ASCII
Content-Transfer-Encoding: 7BIT
Hey Art,
Where can a get a used kingpin reamer (for a Midget) for $70? Do any
parts suppliers sell used ones? I've seen new ones for $200, but I
can't bring myself to spend that much.
-NORY
Don't assume that because you have found one problem, you have found the
ONLY problem.
'71 5-speed Midget (my new baby)
'74 Midget & '71 parts car
'94 Ford Ranger
'86 Ford Escort
'89 Ford Probe
'96 North American Shepherd
'94 Tigger Cat/Wheel Chock
Car pages and other stuff:
http://www.geocities.com/SiliconValley/Way/9101
Home Improvement Homepage:
http://www.angelfire.com/ny/nory
NEW Legal / Law Enforcement Page:
http://members.tripod.com/~nory
--WebTV-Mail-537818945-1138
Content-Type: MESSAGE/RFC822
Content-Transfer-Encoding: 7BIT
Date: Thu, 30 Apr 1998 07:30:33 -0400 (EDT)
From: Art Pfenninger <ch155@FreeNet.Buffalo.EDU>
To: Trevor Boicey <tboicey@brit.ca>
cc: "mgs@autox.team.net" <mgs@autox.team.net>
Subject: Re: Lower kingpin loose
In-Reply-To: <3547BF9C.678DB818@brit.ca>
Message-ID: <Pine.SUN.3.96.980430072500.29776B-100000@freenet.buffalo.edu>
MIME-Version: 1.0
Content-Type: TEXT/PLAIN; charset=US-ASCII
Sender: owner-mgs@autox.team.net
Precedence: bulk
Reply-To: Art Pfenninger <ch155@FreeNet.Buffalo.EDU>
Your king pins are bad and need to be replaced. Because of sale
prices now is a good time to at least buy a major suspension kit. It can
be had for about $90 American and includes everything needed to do the
job. You will also need a reamer (a used one is about $70) or have the job
done for you for $80, this is the way that I would go. I did an article on
rebuilding the front suspension if interested.
...Art
On Wed, 29 Apr 1998, Trevor Boicey wrote:
> Another "found it on the inspection" problem, the lower
> connection of the swivel arms on my B are loose, so I am
> told. It appears to be where a bushing goes through the
> kingpin and through the A arms.
>
> Are there any non-replacement ways to solve this problem? Can
> it be bored over and a larger diameter bushing used?
>
> Thanks in advance. Any stray characters in this post were courtesy
> of my cat.
>
> --
> Trevor Boicey, Ottawa, Canada.
> tboicey@brit.ca, http://www.brit.ca/~tboicey/
> [ Seeking some miscellaneous MG parts, see the list on the web page... ]
>
--WebTV-Mail-537818945-1138--
|