Mark & Simon:
I also have tried a Mighty Vac and have problems with it sucking
air around the bleeder screw. Thus you don't know if the air is
in the brake lines.
I read somewhere that one person reverse bleed the lines as done
in the shop. (S)he purchased a new pump type oil can and using a
hose between it and the bleed screw did the job. Of course the
pump can would probably rust up after the job was done unless you
could figure out a way to keep it from rusting or some way of
cleaning out the brake fluid.
Blake
///
/// mgs@autox.team.net mailing list
/// (If they are dupes, this trailer may also catch them.)
|