OK: Stupid question of the night. I can't get the ujoints to "pop out" as I
am told they will do. I removed the C clips and they move only slightly when
I tap the flanges with a hammer. I hammer and I hammer, but no luck.
Then I tried using a small "chase" , but that only banged up the rubber seal.
Maybe that doesn't matter as I am replacing the ujoints after I paint the
drive shaft.
So stupid question is, how the heck do you do this?
Dennis
/// or try http://www.team.net/cgi-bin/majorcool
/// Archives at http://www.team.net/archive
|