The engine is a 1973 MGB 1800cc
Thanks,
Craig
----- Original Message -----
From: "Craig Straub" <craigstraub@sbcglobal.net>
To: <>
Sent: Friday, August 10, 2007 4:58 PM
Subject: [Mgs] Oil ine fitting - HELP!
> About 2 weeks ago I put my freshly rebuilt engine that was done by a
> machine
> shop back in the car. I started to hook up the ancillaries and found that
> I
> had a problem.
>
> The machine shop had put the oil line fitting in backwards that is
> towards
> the rear of the engine. Normally this fitting takes a 1" socket however
> there
> is a slight factory bulge in the metal line not allowing the socket to
> slip
> over.
>
> Does any one have a suggestion on what to do other than pulling the engine
> out
> again and taking off the back plate?
>
> Thanks,
>
> Craig
> _______________________________________________
> craigstraub@sbcglobal.net
>
> Edit your replies
>
> Mgs@autox.team.net
> http://autox.team.net/mailman/listinfo/mgs
_______________________________________________
Edit your replies
Mgs@autox.team.net
http://autox.team.net/mailman/listinfo/mgs
|