<< On 11/10/2012 7:00 PM, Glenn Schnittke wrote:
> Anyone have an idea where one could source a 1/2" ignition wrench? >>
Glenn & guys;
I seem to recall Snap-On selling a three (3) piece SET of "Ignition
Wrenches" MANY, MANY years ago.
However Glenn & IIRC, the largest was 7/16" & 3/8" then 3/8" & 1/4"
them 1/4" & 3/16". All three
(3) were of thin-wall construction with both 'heads' at 90 degrees to
the shaft.
As usual, Snap-On would & did sell the wrenches separately <VBG> ! ! !
Sorry Glenn, but I do NOT re-call a 4th wrench with would have been
7/16" & 1/2" or the "set" starting there and going down in size (I am
next to positive on this - LOL) ! ! !
If I can find my 7/16" & 3/8" wrench, I get ya'll some pics and
measurements.
'Big' one is about three.five" ( 3 1/2") long.
Ed
Please visit MY site at:
www.justbrits.com
PS: <lite bulb going off> Eureka, Sears had a roll-up kit in red
plastic & IIRC, wrenches were Craftsmen.
_______________________________________________
Mgs@autox.team.net
Archive: http://www.team.net/archive
Unsubscribe: http://autox.team.net/mailman/options/mgs/mharc@autox.team.net
|