| To: | Ole Trucks <oletrucks@autox.team.net> |
|---|---|
| Subject: | Re: [oletrucks] Tool Question |
| From: | WR Teto <monadnoc@crystal-mtn.com> |
| Date: | Mon, 06 Sep 1999 09:16:08 -0400 |
Closest thing I have seen Bill, is a Dremel, but the cut-off disks come in 1-1/4" diameter at the largest. I have not seen an electric one that will take a 1/4" shank. Would be worth looking into though. I will check some of the industrial catalogs at work. Wally > > Does anyone know if someone manufactures a cutoff tool that runs on > electricity rather than air. I don't have anywhere to put a compressor. > Thanks in advance. oletrucks is devoted to Chevy and GM trucks built between 1941 and 1959 |
| <Prev in Thread] | Current Thread | [Next in Thread> |
|---|---|---|
| ||
| Previous by Date: | Re: [oletrucks] Tool Question, Wayne Osborne |
|---|---|
| Next by Date: | Re: [oletrucks] Tool Question, Tim and Terese |
| Previous by Thread: | Re: [oletrucks] Tool Question, Wayne Osborne |
| Next by Thread: | Re: [oletrucks] Tool Question, Tim and Terese |
| Indexes: | [Date] [Thread] [Top] [All Lists] |