In a message dated 10/26/99 3:06:12 PM Pacific Daylight Time,
cramey@n-link.com writes:
> If I remember.... There is a brake light warning switch. If the back or
> front brakes lost pressure (leak?) this switch operated a dash light.
> maybe, been a long time.
I think you're right, I received another email stating that the person had
a wire running from his to the firewall, looks like someone took part of the
pressure/low level switch off.
Thanks for the info.
Mike
> ----- Original Message -----
> From: <Passnb4U@aol.com>
> To: <oletrucks@autox.team.net>
> Sent: Tuesday, October 26, 1999 4:12 PM
> Subject: [oletrucks] Hmmn, power brake Master Cylinder setup question
>
>
> > I went to PickNPull the other day and pulled a Power Brake setup off a
> '68
> > or
> > '69 Chevy 1/2ton PU. Coming off the Master Cylinder is the proportioning
> > valve, on the bottom of the proportioning valve goes the two brake lines
> for
> > the front and rear, but also in between these two lines is another
> fitting,
> > looks kinda like a barbed fitting, that wasn't connected to anything, and
> I'm
> > wondering what goes there? It's possible that something else went over
> this
> > fitting and all that is left is what I see, but I need to know what it's
> for
> > so
> > I can hook this up properly, I'm converting my '59 chevy PU to power
> brakes.
> >
> > Thanks,
> >
> > Mike
oletrucks is devoted to Chevy and GM trucks built between 1941 and 1959
|