Bob,
The terminal nearest the firewall on top goes to the headlight switch as the
power feed, the center terminal is high beam and the lowest terminal is low
beam....although if you mix the high and low beam it won't matter, it is
just switching between one circuit or the other.
Gordon
-----Original Message-----
From: owner-oletrucks@autox.team.net
[mailto:owner-oletrucks@autox.team.net]On Behalf Of jack halton
Sent: Sunday, October 31, 1999 2:43 PM
To: Bob Welch; Old Trucks Listserver
Subject: Re: [oletrucks] TF Dimmer Switch
The feed from the headlight switch should go to the "bat" terminal. The
other two don't matter.
Jack / Winter Park FL
----- Original Message -----
From: Bob Welch <rwelch@ionet.net>
To: Old Trucks Listserver <oletrucks@autox.team.net>
Sent: Sunday, October 31, 1999 3:45 PM
Subject: [oletrucks] TF Dimmer Switch
> I've been rewiring my 56 with an aftermarket wiring harness. The
headlight
> dimmer switch they sent doesn't fit my truck so I need to put the original
> back in. Unfortunately, I their color scheme doesn't follows the stock
> system - I removed all the old wiring anyway. Can anyone tell me which of
> the three leads on the switch is the main feed, low, and hi beam as it
sits
> mounted on the firewall? The factory assembly manual doesn't indicate
which
> is which. Thanks. -Bob
>
>
> oletrucks is devoted to Chevy and GM trucks built between 1941 and 1959
>
oletrucks is devoted to Chevy and GM trucks built between 1941 and 1959
oletrucks is devoted to Chevy and GM trucks built between 1941 and 1959
|