oletrucks
[Top] [All Lists]

Re: [oletrucks] Temp gauge problems

To: oletrucks@autox.team.net
Subject: Re: [oletrucks] Temp gauge problems
From: B&A Kettunen <bekett@uslink.net>
Date: Tue, 11 Jul 2000 22:50:49 -0500 (CDT)
Don't know about that particular one, but most GM products back then should
be pretty much the same.

First, rule out a stuck open thermostat.

If you disconnect the wire from the sender, the guage should read full
cold.  Ground the wire from the sender and the guage should read full hot.
If it doesn't read full hot, there is something wrong with the wire from
the guage to the sender.  If the guage always stays low, and shorting the
wire shows full hot, there is something wrong with the sender.  Check that
there is no sealing compound interfering with the ground of the sender to
the engine.  If this doesn't do it, replace the sender.

Blessing every minute I spent with my dad working on these things when they
weren't such oletrucks.

Bruce Kettunen
57 3200
Mt. Iron, MN

>The water temp gauge in my 57 GMC truck (stock 347" Pontiac
>V8) has recently started reading very low.  The wiring from
>gauge to sending unit checked OK with a meter and the gauge
>is receiving the proper +12VDC on the upstream side.  The
>gauge does move up slightly as the engine heats up, but
>never exceeds 140 degrees.  I really doubt the engine is
>running that cool as the air temp here today is above 95.
>
>I do not know if the problem lies with the gauge or sender.
>The sender in my truck is GM part # 1513210.  It was used
>on all V8 trucks from 55-59.  Any of you have one that you
>want to get rid of?
>
>Any of you ever troubleshot this circuit with a meter?  If so,
>what should the resistance of the sender be when cold?  Hot?
>oletrucks is devoted to Chevy and GM trucks built between 1941 and 1959



oletrucks is devoted to Chevy and GM trucks built between 1941 and 1959

<Prev in Thread] Current Thread [Next in Thread>