Do these seat belt kits work with 5 windows?
-alfie
On Fri, 4 Aug 2000, Stephen wrote:
> I used Juliano's 3-point belts in my '58 Fleetside with large rear window.
> I am very impressed with the weight (strength) of the components.
>
> I did cut a section out of the post, trimmed the mounting plate from the
> belt kit and welded it in place. I think it is the only way to get a very
> secure shoulder point installed. The other two points are bolted through
> the floor into the very large and heavy plates supplied. I shaped a piece
> of 1/4" steel to fill in a space under the door side of the belt in order to
> get a good flush to the floor fit for the Juliano plate.
>
> I hope this helps.
>
>
> Stephen
> '50 Chevy Suburban
> '58 Chevy Fleetside
>
> Arcata, California
>
>
> ----- Original Message -----
> From: "Claude" <cramey@dashlink.com>
> To: <oletrucks@autox.team.net>
> Sent: Thursday, August 03, 2000 9:10 PM
> Subject: [oletrucks] seat belts
>
>
> > What kind of seatbelts is everyone using. I currently have none on my '59
> > but have been thinking about getting the 3 point seat belts. Are any of
> you
> > using the 3 points. If so, where did you get them (from a donor vehicle,
> > vendor)? I was looking at the belts in a standard pickup, seems like they
> > would work. I was also looking at some vendors and found a place called
> > G.E.M. Street Rod Products that advertises 130" 3 point retractable for as
> > low as 56.95. Anyone ever deal with this company? Anyone know how the top
> > piece attaches to the post? I heard you have to cut a notcch out and weld
> a
> > new piece in.
> >
> > Claude
> > 1959 Apache Fleetside
> > http://www.dashlink.com/~rameyfam
> >
> >
> > oletrucks is devoted to Chevy and GM trucks built between 1941 and 1959
> >
>
> oletrucks is devoted to Chevy and GM trucks built between 1941 and 1959
>
oletrucks is devoted to Chevy and GM trucks built between 1941 and 1959
|