Re: [oletrucks] Split Manifold

[Gordon Groves <ggroves100@earthlink.net>]

Inliners.com has an article on running a copper heater pipe from the
fentons to a 1/4 in. aluminum plate that you fabricate to match the spot
where the two stock manifold bolt together supposedly this help warm up
the carbs in colder climes (if you haven't seen them up close the
Fentons have a threaded hole in them for the heater pipe)

Gordon Groves

'51 Chevy 1/2/ ton
'54 IHC Travelall

oletrucks is devoted to Chevy and GM trucks built between 1941 and 1959