oletrucks
[Top] [All Lists]

Re: [oletrucks] clutchhead sizes?

To: drducttape@hotmail.com, oletrucks@autox.team.net
Subject: Re: [oletrucks] clutchhead sizes?
From: New Mexico Jim <ADvent@thuntek.net>
Date: Wed, 23 Aug 2000 10:28:37 -0600
I used a pneumatic chisel at a 45 angle and just using enough pressure to keep
the chisel at the head of the clutch head and blipped it a few times and the
vibrations vibrated the rust and crud loose enough to remove without twisting 
the
head off or rounding out the clutch head hole. Works pretty good. I did it this
way on the trans cover on the floor board of my '50  ton.

Pastorjon994@cs.com wrote:

> Don,
>     I did get a clutchhead bit to work on those.  I twisted several screws
> off so be careful. If I could only remember which one that I used.  I think I
> have a 1/8, 3/32, 3/16, 1/4 and 5/16.
>
> Jon Callahan
> '50 3100
> Champaign/Urbana, Illinois
> oletrucks is devoted to Chevy and GM trucks built between 1941 and 1959

oletrucks is devoted to Chevy and GM trucks built between 1941 and 1959

<Prev in Thread] Current Thread [Next in Thread>