Here's a "bad" picture of the shock mount I made. Its just a piece of 3/8
metal formerly a bracket from some metal frames. It was already bent at 90
degrees and had the hole where the shock fits in it. I just drilled holes
for Ubolts and it works fine. I use a similar setup for damper bracket, just
turned to the inside.
I think I still have my old shock brackets, if you think you need 'em just
pay postage from Texas and round up to the next dollar, unless you want to
just come get 'em.
----- Original Message -----
Sent: Friday, November 16, 2001 8:51 AM
Subject: [oletrucks] wanted: 57 front lower shock mount
> Looking for a passenger side lower shock mount for my 57. I want to make a
> steering damper bracket, if anyone has one or a suggestion for a good
> I appreciate it. Thanx neal
> oletrucks is devoted to Chevy and GM trucks built between 1941 and 1959
oletrucks is devoted to Chevy and GM trucks built between 1941 and 1959