oletrucks
[Top] [All Lists]

Re: [oletrucks] thermostat housing

To: "Tom" <tomntam@earthlink.net>, "Oletrucks"
Subject: Re: [oletrucks] thermostat housing
From: Bob Fischer <bfischer@utm.net>
Date: Sun, 25 Nov 2001 13:01:11 -0800
>I had to buy a thermostat housing today for my 350 Chevy engine and the one
>I got has a rubber o-ring built in to the bottom of it. Has anyone used one
>of these and if so did it work and do I, or should I, use a standard gasket?
>

They work fine without the normal gasket, but with a bead of silicone 
sealant around
the outer surface, away from the O-ring. I have one on a Ford 289 and two 
SB Chevys
with no leakage problems.
The best IMHO thermostat housing is an  original cast iron type. These off 
shore produced
pot metal types seem to dissolve in what appears to be a short time, using 
either straight
H2O or the normal 50% anti-freeze solution.

"Nothin lasts forever except old Fords and a natural stone" - Willie Nelson

http://home.utm.net/bfischer      e-mail -->bfischer@utm.net
oletrucks is devoted to Chevy and GM trucks built between 1941 and 1959

<Prev in Thread] Current Thread [Next in Thread>