First thing I checked Bruce, I don't have anything on the threads
or any loose wires I can find , new wiring harness
but thanks
HooT58
----- Original Message -----
From: "Bruce Kettunen" <bekett@uslink.net>
To: <oletrucks@autox.team.net>
Sent: Monday, July 01, 2002 10:05 AM
Subject: Re: [oletrucks] Heat Guage
> Sounds like you have a loose wire somewhere or that you used some
> kind of sealing compound on the threads when you put the sender in.
> Bounce to hot indicates infinite resistance.
>
> Bruce K
> 57 3200
> Mt. Iron, MN
>
> At Sunday, 30 June 2002, you wrote:
>
> >I need help on my heat gauge, I have put in my third dash
> >unit and get a different response each time.
> >The sending unit I bought from Chevy Duty seems to be
> >working fine, 0 ohms when cold and an increase in ohms
> >when heated, there is voltage coming from the dash unit.
> >when engine is started gauge perks up to were it belongs
> >then in a few minutes it pegs out to the hot side.
> >any and all suggestions are welcome.
> >Thanks in advance
> >HooT58
> >oletrucks is devoted to Chevy and GM trucks built between 1941 and 1959
> >
>
>
>
>
> ===================================================================
> EASY and FREE access to your email anywhere: http://Mailreader.com/
> ===================================================================
> oletrucks is devoted to Chevy and GM trucks built between 1941 and 1959
oletrucks is devoted to Chevy and GM trucks built between 1941 and 1959
|