No No No No!!! It's to let the mice, snakes, and bugs OUT! You don't want
them TRAPPED in there! By the way, to any of our members who are going to
the Brothers show in Anaheim, I am old, grey haired, have a grey beard, am
slightly plump, wear glasses, and will be wearing a straw hat. See you
there. BK
----- Original Message -----
From: "Hanlon, Bill (ISS Houston)" <bill.hanlon@hp.com>
To: "Spencer" <wits_end@worldnet.att.net>; "Dane Bruce"
<nochay@earthlink.net>
Cc: <oletrucks@autox.team.net>
Sent: Friday, July 18, 2003 12:06 PM
Subject: RE: [oletrucks] Bottom of cab
> The hole is designed to let the mice and snakes in when pickup is stored
in a barn. Leave it.
>
> -----Original Message-----
> From: Spencer [mailto:wits_end@worldnet.att.net]
> Sent: Friday, July 18, 2003 1:10 PM
> To: Dane Bruce
> Cc: oletrucks@autox.team.net
> Subject: Re: [oletrucks] Bottom of cab
>
>
> The mystery hole is located approximately over where the front U-joint
would
> be, about 18" forward from the hole the gas line feeds through. I'm
> wondering if I can weld it shut. Harry
>
>
>
> ----- Original Message -----
> From: Dane Bruce <nochay@earthlink.net>
> To: 'Spencer' <wits_end@worldnet.att.net>
> Cc: <oletrucks@autox.team.net>
> Sent: Thursday, July 17, 2003 6:36 PM
> Subject: RE: [oletrucks] Bottom of cab
>
>
> > Hey Harry,
> >
> > 2. there is a hole in the center of the cab floor directly under where
> > the
> > seat would go. It's about an inch in diameter with a good sized notch
> > on
> > either side. Anyone know what it is for?
> >
> > Closest I can think of would be for the master cylinder service hole. Is
> > it about that size? My mom's truck has one similar to what you are
> > describing.
> >
> > Dane
> oletrucks is devoted to Chevy and GM trucks built between 1941 and 1959
> oletrucks is devoted to Chevy and GM trucks built between 1941 and 1959
oletrucks is devoted to Chevy and GM trucks built between 1941 and 1959
|