Air chisel? Drill?
Some pictures might help, can you post some somewhere?
----- Original Message -----
From: "William Schickling" <wschick1@twcny.rr.com>
To: "Oletrucks" <oletrucks@autox.team.net>
Sent: Saturday, September 27, 2003 4:48 PM
Subject: [oletrucks] Breaking old welds
I am trying to get the frame of my truck completely stripped of all
components before it goes to the sand blaster. At some point an owner of the
truck welded a Reese (sp?) hitch onto the back of the frame. A couple of
problems for me. One is the brackets are weld over the bolts that the rear
bumper brackets use to attach to the frame rails. The other some of the
welds are damn near impossible to get at. I cut out the bulk of the home
made brackets and the hitch is removed. However I need to remove the
remaining junk.
I have tried using an angle grinder to attack the old welds, an although
messy, it seams like I could get some of them this way. There are others I
won't be able to get at this way.
I don't own any welding equipment, but my neighbor has a sears oxy/mapp
torch if this could help.
What is the best way to remove or break these old welds?
Bill Schickling
oletrucks is devoted to Chevy and GM trucks built between 1941 and 1959
oletrucks is devoted to Chevy and GM trucks built between 1941 and 1959
|