I can handle drilling a few holes. Just didn't want to get into any
major slicing and dicing.
Thanks Jim!
Sent from my iPhone
On May 6, 2010, at 2:26 PM, "Jim Krontz" <jim_krontz@yahoo.com> wrote:
> I have a 57 3100 and purchased a 56 GMC as a donor truck. The front
> fenders
> lined up pretty good. You will have to do a little modification
> (drill a
> few holes for the grill), but not too difficult.
>
> Picked up the GMC because the cab was in MUCH better shape than the
> 57s, and
> then I had the added benefit of striping all the parts I needed.
> Then sold
> the 56 to another guy for about half of my cost. All in all, I was
> out
> about $700, but picked up the cab, two front fenders, and two rear
> fenders...
>
> Good luck
>
> Jim
> 57 3100
> Mesa, AZ
>
> -----Original Message-----
> From: oletrucks-bounces@autox.team.net
> [mailto:oletrucks-bounces@autox.team.net] On Behalf Of Rob
> Sent: Thursday, May 06, 2010 11:06 AM
> To: oletrucks@autox.team.net
> Subject: [Oletrucks] GMC vs Chevy TF fender question
>
> I need some input on the differences between GMC and Chevy Task
> Force front
> fenders. Is there any real difference? Can you install a Chevy
> grill,
> specifically a '57? I have been offered a '57 GMC 1/2 ton long bed
> factory
> V8 truck for $1000 and would love to pull the GMC bumper/grill and
> dress it
> as
> a '57 Chevy. Is it as simple as just installing the Chevy grill?
>
> Thanks,
>
> Robert
> _______________________________________________
>
> Oletrucks@autox.team.net
> Donate: http://www.team.net/donate.html
> Suggested annual donation $11.47
> Archive: http://www.team.net/archive
> Forums: http://www.team.net/forums
> Unsubscribe/Manage:
> http://autox.team.net/mailman/options/oletrucks/jim_krontz@yahoo.com
_______________________________________________
Oletrucks@autox.team.net
Donate: http://www.team.net/donate.html
Suggested annual donation $11.47
Archive: http://www.team.net/archive
Forums: http://www.team.net/forums
|