at least 300F and then form this over a wooden base covered in felt and let
cool to harden in place. If you are going to use a metal form, then cover
it in felt to prevent any scratches or possibility that the plastic will
take any impressions from the metal you are using.
Also a warning note- acrylic/plexiglass can give off nasty fumes, some of
which are combustable so do this in a well ventilated area!
Dan C.
[This message delayed, as it needed manual intervention by the list
administrator. mjb.]
///
/// shop-talk@autox.team.net mailing list
///
|