Re: Bending steel

[Steven Trovato <strovato@optonline.net>]

Have you ever done this?  How wide a plate could you heat up and bend with 
a single torch?

At 12:09 PM 9/17/03 -0400, eric@megageek.com wrote:

>There is a special tip for OX-Ace set ups commonly called a "Rosebud."
>
>This will heat up metal without cutting it.  (Note, it uses LOTS of O2)
>
>What you do is hit the metal with this tip until it's red hot along the
>whole joint to be bent.  Then, bend.