shotimes
[Top] [All Lists]

[Shotimes] Re: Spoiler mount hole locations

To: shotimes@autox.team.net
Subject: [Shotimes] Re: Spoiler mount hole locations
From: fwhittle@mindspring.com
Date: Mon, 15 May 2006 01:23:05 -0700 (GMT-07:00)
Here are the measurements:  There are 5 holes for the spoiler's mounting studs 
and 1 hole for the wires.  The 5 mounting holes are 3/8" diameter and the hole 
for the wires is 3/4" diameter.  The forward holes on each end (toward the 
front of the car) are 5 7/8" from the left and right edges of the lid, 
respectively.  Measure with the tape perpendicular to the edge of the decklid 
and to the centerline of the holes.  The 2 holes behind those, toward the rear 
of the car, are 5 3/4" from the left and right edges of the lid.  The distance 
between the centerlines of each pair of holes is 1 25/32".  The rearward holes 
are "about" 1 13/16" from the rear edge of the lid (measure through the 
centerlines of the pair of holes).  I say "about" because the rear edge is a 
radiused edge and is therefore a bit subjective.  I didn't make any effort to 
hold the tape against the lid down to the edge, I just held the tape down at 
the hole and looked down on it as it went off the rear of the lid.!
   You may be up to 1/16" off either way depending on whether you see it the 
same way as I or not.  Probably not enough to make a big difference.  The 
center hole is actually on the centerline of the lid.  Use whatever method you 
wish to find the centerline.  The center hole is "about" 2 7/32" from the rear 
edge of the lid.  That leaves the hole for the wires.  This hole is 3 1/16" 
from the rear edge of the lid and 7" to the right (passenger side) of the 
centerline of the lid.  I don't know if a standard non-spoiler lid will have 
the access holes on the underside for the nuts and the wiring so you may need 
to make those too.  I hope this all makes sense.  If not, let me know.

Frank Whittle
'95 ATX

-----Original Message-----
>Date: Sat, 13 May 2006 13:24:45 -0400
>From: Jon Heese <shotimes@jonheese.com>
>To: shotimes <shotimes@autox.team.net>
>Subject: [Shotimes] Spoiler mount hole locations
>
>I'm in the process of adding a spoiler to a '92 trunklid, and instead of 
>guessing and screwing it up (BTDT), I'm curious if anyone has measured 
>and documented the location of the holes in reference to the edges of 
>the trunklid...
>
>Or, if anybody feels like taking theirs off and measuring the hole 
>locations to help out a fellow SHOwner, please let me know. =)
>
>Regards,
>Jon Heese
_______________________________________________
Shotimes mailing list
Shotimes@autox.team.net
http://www.team.net/mailman/listinfo/shotimes

<Prev in Thread] Current Thread [Next in Thread>