Hi, John.
I would suggest trying to shoot some grease into the rear bearings. I
believe there is a grease fitting on the lower inboard side of the
trunnion housing for that purpose. I didn't know about it and trashed
an axle many years ago.
Donald.
> Anyhow, my questions are: Is there any particularily likely, easy to miss
> (hopefully easy to check :) thing that the folks at Grand Auto may have
> screwed up or overlooked? They replaced the outer bearing, reassembled...
> and the problem (that time the rear brake shoes were dragging every half
> turn or so because the hub/shaft was wobbling so badly) was still there.
> So they discovered an inboard bearing and replaced that too, and that
> solved the problem until yesterday.
>
|