Sorry, let me clarify:
There are two nuts that hold the drivers side of the dash in place as well
as a hook into the center dash piece. The top left screw of the center
console goes through this hook. So, you need to undo the two nuts and
remove the top left screw from the center dash panel. However, since it
is such a tight squeeze, you should probably loosen up all four screws
from the center panel before trying to remove the drivers side panel.
(This is all from a left hand drive car of course, if it's right hand
drive, then you need to remove the top right screw from the center panel)
On Wed, 14 Jul 1999, Craig Smith wrote:
>
> Two nuts & the top left screw from the center piece. ?
> Center piece?
> I felt the two on the far left but where is the center piece?
>
>
> -----Original Message-----
> From: Huw Upshall [mailto:hupshall@WOLFENET.com]
> Sent: Wednesday, July 14, 1999 6:53 PM
> To: Craig Smith
> Cc: 'Spit list'
> Subject: Re: Drivers side dash
>
>
> Two nuts & the top left screw from the center piece.
> It's probably best to loosen the center panel completely to not stress the
> drivers panel as you are removing it.
>
> On Wed, 14 Jul 1999, Craig Smith wrote:
>
> >
> > I was trying to remove the drivers side dash on my 71 spit an it looks a
> > littlel difficult.
> > I felt around behind the dash and felt some small nuts that seem to be the
> > ones to remove.
> > Questions is how many of these little (soon to be cussed) boogers are
> there
> > to remove ?
> >
> >
> > Craig Smith
> > Phone 800/692-2323
> > Fax 864/234-1020
> > craigs@iewc.com
> >
> >
>
|