Doug,
Unfortunately, it does not provide sufficient venting. I found that out
myself quite a few years ago. Providing venting for the crankcase does
resolve the problem.
Joe
-----Original Message-----
From: spitfires-bounces+spitlist=cox.net@autox.team.net
[mailto:spitfires-bounces+spitlist=cox.net@autox.team.net] On Behalf Of Doug
Braun
Sent: Monday, September 22, 2008 7:49 PM
To: Daniel Parrott; 'spitfires'
Subject: Re: [Spits] Fuel Pump Blanking Plate
Does your car still have a PVC setup? If so, there
should generally not be any pressure build-up.
Even if you have no way to hook up a PVC valve
(non-stock carb?), the hose fitting on the rocker arm
cover should be able to provide venting.
Doug Braun
'72 Spit
--- Daniel Parrott <parrotthead01@comcast.net> wrote:
> Does anyone make a pre-fab Fuel Pump Blanking plate
> with a built-in vent for
> a 1980 Spitfire 1500? I'm building up too much
> crankcase pressure and oil
> is spurting out the dipstick (again).
> __
Spitfires@autox.team.net
http://autox.team.net/mailman/listinfo/spitfires
http://www.team.net/archive
_______________________________________________
Support Team.Net http://www.team.net/donate.html
Spitfires@autox.team.net
http://autox.team.net/mailman/listinfo/spitfires
http://www.team.net/archive
|