spitfires
[Top] [All Lists]

Re: [Spits] edge trim source

To: spitfires@autox.team.net, paulfmeyer@msn.com
Subject: Re: [Spits] edge trim source
From: Glenn Franco <gaf3@charter.net>
Date: Fri, 07 May 2010 14:07:30 -0400
:I purchase a couple of rolls of this material from JC Whitney. I 
stopped at their facility when I was traveling across Illinois going 
West (not much to see).
Anyway they had a few widths of the material.
I would go to their website and phone into someone that can help. Their 
website does not seem to be all inclusive of what they have on hand.

Good Luck
Glenn Franco TR6's, 250 and Spit racer
>
>
> Today's Topics:
>
>    1. edge trim source (Paul Meyer)
>
>
> ----------------------------------------------------------------------
>
> Message: 1
> Date: Thu, 6 May 2010 12:17:54 -0400
> From: Paul Meyer <paulfmeyer@msn.com>
> Subject: [Spits] edge trim source
> To: <spitfires@autox.team.net>
> Message-ID: <COL102-W6442C0751689FA1D87E59BCDF50@phx.gbl>
> Content-Type: text/plain; charset="us-ascii"
>
> Listers,
>
>
>
> I'm looking for a source to buy replacement edge trim.
>
> In several locations around the interior of the car, there's a egde trim
> installed.  It's black vinyl with a metal core - it's used primarily to cover
> unfinished edges of sheet metal, notably along the back edge of the car, where
> the interior and exterior sheet metal join.  I tried Moss and VB, but couldn't
> find it.
>
> Paul F. Meyer Home Phone: 781-551-8574 Cell Phone: 781-801-3170 e-mail:
> paulfmeyer@msn.com
_______________________________________________

Spitfires@autox.team.net
Donate: http://www.team.net/donate.html
Suggested annual donation  $11.47
Archive: http://www.team.net/archive
Forums: http://www.team.net/forums

<Prev in Thread] Current Thread [Next in Thread>