| To: | "Triumph List" <triumphs@Autox.Team.Net>, "Spridgets" <spridgets@Autox.Team.Net>, "MG LIST" <mgccnwc-list@eskimo.com> |
|---|---|
| Subject: | oil dipstick tube question |
| From: | "William West" <will_thane@email.msn.com> |
| Date: | Sat, 7 Feb 1998 17:07:38 -0800 |
| Reply-to: | "William West" <will_thane@email.msn.com> |
| Sender: | owner-spridgets@Autox.Team.Net |
Greetings All! How is the oil dipstick tube removed/installed on a spitfidget 1500? Let's just say there was a little 'roll-over' accident with my block, and my tube got bent. I bent it back and it seems to be ok, but now I'm curious as to how it might be removed and replaced. Thanks again! Will |
| <Prev in Thread] | Current Thread | [Next in Thread> |
|---|---|---|
| ||
| Previous by Date: | Re: fact or fiction, jonmac |
|---|---|
| Next by Date: | Re: crank pulley bolt, David Ramsey |
| Previous by Thread: | Re: crank pulley bolt, Frank Clarici |
| Next by Thread: | Re: oil dipstick tube question, Eric Mumford |
| Indexes: | [Date] [Thread] [Top] [All Lists] |