David,
I had the same concerns with sandblasting my springs. I was afraid that
sand may get lodged between the leafs. Depending where I was removing
rust, I used a wire brush (chucked in a drill) or sandpaper. With
patience, they cleaned up pretty well.
Matt
On Mon, 23 Feb 1998 06:27:33 EST Lancer7676@aol.com writes:
>Speaking of leaf springs--what about sandblasting them? Any good
>alternative
>methods of removing the scaly rust to improve appearance and prep for
>painting. Should the leaves be separated for blasting to keep sand
>particles
>from between them, or is this a problem?
>
>----David
> '67 Sprite MKIV, Vicky
>
_____________________________________________________________________
You don't need to buy Internet access to use free Internet e-mail.
Get completely free e-mail from Juno at http://www.juno.com
Or call Juno at (800) 654-JUNO [654-5866]
|