Ulix Goettsch <ulix@u.washington.edu> writes:
>if it's only the speedo, you can just reposition the needle. Check first
>if the needle points at the little mark on the face if you move if over
>the bottom peg. Then you can pull it of and move it relative to that
>mark.
That doesn't work unless it's off by a consistent amount. In this
case it's reading a percentage high apparently; sounds like 20-30% high.
Take it to a speedo shop, or send it to Nissonger.
It's you're using non-stock tires/wheels/rear-end, don't forget
to include that info in the calibration. And use rolling radius, not
just running a tape around the tire, or use manufacturer's spec for rolling
radius.
--
Randell Jesup, Scala US R&D, Ex-Commodore-Amiga Engineer class of '94
Randell.Jesup@scala.com
#include <std/disclaimer>
Exon food: <offensive words no longer censored - thank you ACLU, EFF, etc>
|