Hello all;
I have a '74 Midget with standard carbs. I am having problems getting
the accelerator cable loosened at the connection to the carburator. The
connection on mine has a 1/2 inch nut on one side of the plate connected
to a pin that is held in place on the other side by a cotter pin. I
can't seem to be able to get to it with a standard tool and loosen the
nut enough to slip out the old cable and install the new!! Any
suggestions as to a slick way to do this without buggering up the works
or having to buy new parts when I finally get it off?? I know this
can't be that hard!! But, this is the first time that I have had to do
this. Help!~?
Thanks,
Monty
|