| To: | Butch Lewis <butchl@eudoramail.com> |
|---|---|
| Subject: | Re: 1275 cc Pistons go which way ? |
| From: | Frank Clarici <spritenut@Exit109.com> |
| Date: | Wed, 30 Jun 1999 17:46:02 -0400 |
| Cc: | spridgets@autox.team.net |
| Organization: | Positive Earth Drivers Club |
| References: | <DIJKEOBPMJNBAAAA@shared1-mail.whowhere.com> |
| Reply-to: | Frank Clarici <spritenut@Exit109.com> |
| Sender: | owner-spridgets@autox.team.net |
Butch Lewis wrote: Can someone tell me which way the pistons should be facing ? All of the rods and endcaps are installed in the correct direction. Butch It seems your engine has replacment pistons. If this is the case, the replacments are omnidirectional. They may have been fitted to the rods in different directions. It will not matter. The rods only fit the engine one way. If they are wrong, it will not crank over without the rods hitting the block. -- Frank Clarici Toms River, NJ Bugeye Sprite 67 Sprite 59 A40 http://www.exit109.com/~spritenut/ |
| <Prev in Thread] | Current Thread | [Next in Thread> |
|---|---|---|
| ||
| Previous by Date: | Ground Clearance, Larry Miller |
|---|---|
| Next by Date: | Re: LBC question (no one unsubscribe, please), Frank Clarici |
| Previous by Thread: | 1275 cc Pistons go which way ?, Butch Lewis |
| Next by Thread: | Duct Tape (Duck Tape?), Paul A Asgeirsson |
| Indexes: | [Date] [Thread] [Top] [All Lists] |