Easy to do. Take out the old one and replace it with a piece of 1/2" heater
hose 1 7/8" long. Spray the hose and the fitting on the block/head with
WD40, buckle the hose, as in sorta fold it, and put it in place. Put on the
clamps, tighten and refill with coolant.
Don't use the bellows type hose as it's a genuine POS!
----- Original Message -----
From: "Billy Zoom" <email@example.com>
To: "Spridget List" <firstname.lastname@example.org>
Sent: Friday, March 17, 2006 2:53 PM
Subject: Nipple enhancement
> Have any of you ever managed to replace the water pump bypass nipple in
> head without removing the head? Also, where can I get a new one? I don't
> them in the usual catalogs.